First, You must know before using: 1. popcorn machine should be kept at room temperature below 40 ℃, ventilated, non-corrosive gas environments under. 3. Equipment should lie flat with less than 3 ° tilt fuselage appropriate.
Second, transportation and storage: During transport, popcorn machine surrounded by glass should be handled with care to prevent the severe vibration, packaged popcorn machine Usually not a long-term open storage, should be placed in ventilated, non-corrosive gases warehouse shall not upside down, Deposit required on a temporary open-air place, measures should be taken rain.
Third, Instruction manual:
Electrical connection and installation required to hold a license electrician install, installed after properly, use the following procedure. 1. Plug three pole plug energized, pressing the insulation light switches, to lighting and insulation. 2. Turn the heating switch, 5-6 minutes to warm popcorn pot. 3. Open the stirring motor switch to refuel, plus corn (maize imported or domestic baby corn) and sugar (no Coke Sugar) into the pot, put the pot admonish closed tambour, you will hear the sound at the beginning of popcorn, popcorn close at the end, After the burst of good will from the top popcorn lid, overflow pans until you do not hear the sound of popcorn, a clockwise twist boom Handle bombs from the top plate, popcorn pot calling was unilateral, this time can be completely poured popcorn. (Rotated to the popcorn pot Shaped mouth down bottom up, this time can be completely poured popcorn pot) 4. Repeat step 3, you can burst more popcorn, each only about 2 minutes. 5. put the oil to be careful to prevent burns, the oil droplets can not drip onto the soup, keep the popcorn pan clean. 6. This machine has overtemperature protection, when the temperature is higher than the normal operating temperature, over-temperature protection will cut off the power play Paul Protect the machine and user safety.